Epilog Laser Cutter Settings
1 - 5 of 5 Posts
Joined
·
114 Posts
I only tried it once years ago because I had to make 1 custom applique. I played with it a couple of times and only remember it was high speed and low power. The first time I remember I had too much power and the edges appeared burnt. Just cut a couple of 1" squares till you get it right. In less than an hour you should get acceptable results. Only change one setting at a time so you know what is working. Good Luck!
Thanks CLS for the reply...
Just in case anyone was wondering for future reference, I played around a bit with the settings and came up with 80% speed/15% power/400 frequency and it cut perfectly thru 1 sheet of twill.
Now lets see what it can do for 5 sheets at a time...
Just in case anyone was wondering for future reference, I played around a bit with the settings and came up with 80% speed/15% power/400 frequency and it cut perfectly thru 1 sheet of twill.
Now lets see what it can do for 5 sheets at a time...
Joined
·
2,510 Posts
What wattage laser?
1 - 5 of 5 Posts
