T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi there,

New to the forum so hello to everyone first of all.

I have a question about Eh721 Vinyl cutter. I purchased one last week and im using Flexisingpro10 software.

When I send a design to cut basic letters and designs dont fully cut. There is a slight break, as if the vinyl cutter couldnt be bothered finishing the job off. Its individual letters like it doesnt cut the full shape of a letter A all the way round, it just falls short every time.

Any ideas ?

Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top