T-Shirt Forums banner

easy weed and 3G jet opaque

1379 Views 2 Replies 2 Participants Last post by  mailman
I hope I can explain this correctly, If I use easy weed for lettering on shirt,and 3G for the graphic, I guess I would have to do this in two steps since times and temp are different? Is there any certain order I should do this or does it matter. Does re-heating one or the other make a difference, since one will be heated twice? Thanks, Mark
1 - 3 of 3 Posts
Always press the one with the highest temp first. I do vinyl and JPSS all the time. Remember to use either teflon or parchment paper to protect your G3 and you upper platten when pressing the easyweed.
Thank you very much, little by little with everyones help I am catching on. Mark
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.