T-Shirt Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter · #1 ·
Hi all,
I was using messing with a print head trying to get it cleaned out and the nozzle plate came off.
Does anyone know if there is some kind of sealant on it I am not seeing?
Has anyone ever put one back on without it leaking and been able to get it in the perfect position as to not mess up the ink spray?
Is it a goner and you know this from much experience?
 

·
Registered
Joined
·
35 Posts
Discussion Starter · #3 ·
Can you be more specific?
I see or feel no type of adhesive or sealant here and the pins that go into the two holes on the nozzle plate seem like they would make for easy alignment.
As easily as it came off I am assuming it is the metal bracket that was holding it on because it was fine until i removed that.
 

·
Registered
Joined
·
35 Posts
Discussion Starter · #11 ·
And the real problem here is not the nozzle plate it is these print head "cleaners" I am not sure what the ones for dye ink are like but these pigment ink ones which i have tried about 30 different types of only partially work.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top