T-Shirt Forums banner

DuraCut Questions

875 Views 1 Reply 2 Participants Last post by  MotoskinGraphix
Recently I received some sample sheets of DuraCut. I had a couple of onesie-jobs that I decided to use it on and try it out, since I didn't have a whole lot of it.

I followed the directions including peeling it cold. When I did, the paper stuck to the design and I couldn't peel it off. I pressed the design again and peeled it hot, and it finally came off.

Has anyone else had this experience? I know it's not my heat press, because I haven't had any problems with the other vinyl and transfers I've used. Any ideas??
1 - 2 of 2 Posts
Dura cut is a cold peel ink based cad cut product. My friend uses it and I have some samples but never pressed it myself. I do know cold peel materials are a bit harder to remove.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.