T-Shirt Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Hi there,

I hope you guys can help me here.
My DTG Viper is not aligned right to left. I have a print that looks like it has a shadow on it.

Printing one colour or white based both have the shadow look.

I am glad fro any help.
Cheers
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
First of all thanks Anthony.

Shirtboard is leveled and the Gap is fine. I did as you said and printing on uni directional mode it works perfect. However if I put bi directional same problem happens.
 

·
Registered
Joined
·
67 Posts
Hello Tiago,

i think that there is not enough tension on the belt from the carriage of the printer, or the drive gear is a little bit lose, or the screwsof the motor from the drive are lose.
Maybe is the transparant strip to lose.

Take a look.

Succes,
Pierke
 

·
Registered
Joined
·
10 Posts
Discussion Starter #6
Hi there,

Thanks again lads...

It looks like there are enough tension both belt and encoder strip.

Still the only way to get a good print is printing on uni-direction.

Any other ideas that I could try?
 

·
Registered
Joined
·
10 Posts
Discussion Starter #7
Hi there,

I am still only printing on Uni-Direction, it takes ages :mad:.

Still I cannot find out where the problem is.

Help!?:confused:
 
1 - 8 of 8 Posts
Top