T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
Hi anyone had this problem our viper stopped midway through a print and started flashing blue then we could not use any of the buttons on the control panel other than on and off does anyone have any helpful advice I have had a good look through the forum and only found that our gap button may be on regards Di
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top