T-Shirt Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
348 Posts
You should not have any clogging problems if you keep everything clean and do a white ink print daily. Also leave the machine turn on at all times so it will do automatic head cleans if fitted with a wins board. Swirl white inks daily n bottles and leave settel againg for 15 mins before printing or doing a head clean etc so to avoid sucking air bubbles in tubs or printhead. I keep 2 marbles in each of my bottles and just give a little swirl motion each Morn and Night they work a treat. Alot of people do way to many head cleans in a row and this seems up upset the print head and you will not get a perfect nozzel check if you leave machine again for a while and come back it normally does settle and work again. Also keep cleaning fluid in capping station when not in use and whipe gently the print head itself with soft paper towels with cleaning fliud on it and then press a clean one on the print head also soaked in cleaning fluid to get a little fluid into the nozzels before removing paper towle and putting back over properly on the capping station. Remember to keep capping station and rubber seal on it very clean without damaging it and also print head silver strips on both ends clean. You should not have any problems at all. Good luck.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top