T-Shirt Forums banner

DTG Kiosk 3 K3 Raptor replacing parts for white inks system

2176 Views 3 Replies 2 Participants Last post by  dazzabling
what parts will I need?
where I can get those parts?
how do I change the tubes? and how?

tubes,
ink dampers,
white ink filters
and???
1 - 4 of 4 Posts
How's your printhead and capping station?

Do you have ink in the color lines?
my CMYK prints fine. yes theres still some white ink in the lines
Ok..you are going to need to make sure that you keep all parts moist.

Capping station
Ink lines
Printhead

If you dry up the capping station especially the white part there is no recovering it.

If it's going to be awhile until you get all the replacement parts..flush all the lines.keep flush in the lines and fluid in the capping station.

You can run head clean and purges with 50% distilled water and 50% household ammonia. Do not keep in the lines for very long. Then a warm distilled waste flush to remove the ammonia.

do you have bags or bottles?
See less See more
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top