T-Shirt Forums banner
1 - 9 of 9 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
Hi,all
Thanks to this forum.
I builded DTG printer from many threads.
I have finished my DTG Epson T1100 and T13 with aluminum profile.
My project almost finish(+90%) as picture & clips below,

epson T1100.m4v - YouTube


but today i got problem with EEPROM, that i try to adjust some of parameter
(Head angular adjust PF adjust ect.)
then replace it over original EEPROM. (fogot to Backup it !!)

I need much help, with firmware file (**.eep) from your Epson T1100
that i can reset all parameter back to default factory set.

I wish somebody can help me. * *send file .eep to [email protected]
( you can look over this file at your " C:\Adjustment Program\Epson Stylus Office T1100 " )
Thank for advance.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top