T-Shirt Forums banner

Driver needed for COTEK CTK-720C

10232 Views 6 Replies 6 Participants Last post by  PressCutandPrint
Hello

I got a COTEK CTK-720C extremely cheap but I cannot seem to get it
communicate with Artcut. Device manager shows

This device cannot start. (Code 10)
A device which does not exist was specified.

The drivers I got with it don't install, Do i need XP to get it to
work or is there a way round it?

I'd really appreciate some help

Thanks
1 - 7 of 7 Posts
I used SignBLazer elements. My cutting plotter used to work until win10 did an update now i cannot seem to cut anything from signblazer with my cotek CTk-720C. I am not sure what is the problem need help.
I am also looking for the driver maybe that will correct my problem.
Hi Yolandi. Did you manage to sort out the problem?
Hi, I bought a similar cutter YH-720 and had a same problem. What you need is a CH341 driver. I got it here. CH341PAR.EXE - 江苏沁恒股份有限公司
Hello i have a same problem. could someone help me. I have Cotek 48" wide on windows 10 Unknown Usb device.

is somebody have solution thanks!
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top