T-Shirt Forums banner

Dri-Fit Printing

1122 Views 0 Replies 1 Participant Last post by  patnewk76
I've got a question, that so far have not found an answer for, but is it possible to use WB inks on Dri-Fit shirts? I've done Tri-Blends w/no problems, but after reading some of the threads on here, I've gotten quite nervous about it. I'm still new to this and learn everyday.

Looking at printing on a Lime Green colored shirt. If water based can't be used, what would be best for this? I've read that a Low Bleed as an under then you can add on top of that. The design right now has red and black in it, but that was based on a gray shirt, but that might still be ok on the Lime as well.

Any help would be great, and I'm going to keep reading and searching on here. Thank you...
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top