[aaronc]

So, I did an entire run of white plastisol on drawstring backpacks. I ran them through the conveyor at about 400 deg (any higher and they start to shrink/melt) ... my customer said that some of them were rubbing off. The ones they had were samples and only ran through once. If I run these through again, will it fully cure, or is that never going to happen?

 

[candimantint]

I could not even get mine to run at that high temp. They would shrink up. I flash mine and heat pressed them for a couple of seconds, i was too scared of the ink coming off. Mine were nylon so had to use the nylobond catalyst.