T-Shirt Forums banner
1 - 2 of 2 Posts

389 Posts
Discussion Starter · #1 ·
I use a 16'x16' "aforda flash" unit to flash and cure. When I cure the middle heats up faster than the sides.

I have Lawson 1550 super bright white. I do a print flash print and if I do good prints the initial end result looks awesome. It looks just right.

If it doesn't get to hot during the cure it still looks the same. If it gets too hot the nice soft white turns rough and shiny.

Then during the cure, by the time that the edges of my 11" wide print get to 320, the middle of the print is already turning rough and shiny.

I was thinking of trying another companies white. Since I don't have a conveyor dryer, what is the best way to deal with this effect?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.