T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
219 Posts
Discussion Starter · #1 ·
I just bought the upgrade for the silver press 4/1 to turn it into a 4/2 and I am confused. The video and the info is saying that there should be a piece on each end of the arms one is the flash side and one is the print side. Well the one I just got has the bar on one end and a skateboard wheel on the other? Did I miss something? The instructions that came with it illustrate the skateboard wheel and not a bar on the other end. I am confused. I am going to call tomorrow I was just curious if anyone had this?

Also on the print end where the white bar is the print arm doesn't even touch it so what is going to keep it from moving?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top