T-Shirt Forums banner

Does any body try to cut inkjet magnet on a cutter?

1987 Views 3 Replies 4 Participants Last post by  2dsign
I just wanna know if i can cut a magnetic sheets on a cutter and what blade do i need to used? I have Craftrobo Pro 15".
1 - 4 of 4 Posts
That will put quite a bit of ware and tear on your machine. I would advise against it. If you are doing large runs of them, look into die cutting.
  • Like
Reactions: 1
Well if your using a vinyl cutter you don't cut all the way thru and just score it.
I heard doesn't really do a whole lot of damage to machine
but will wear down knife a little
go to minimum gram force and to lowest speed on your machine.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top