T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
105 Posts
Discussion Starter · #1 ·
Anyone know how the pressure sensors work on these? I have a new lower platen and the "alignment wings" are a little tight so my pressure indicator doesn't seem to work properly.

I see there is a way to calibrate it but I don't want to mess up the settings for my 16x20 table in the event that it is the new platen that's too tight. Seems odd that if the auto, pressurized units, have PSI indicators that they don't have them on the manual units.

As I'm really new to production, can you give me an estimate about what it feels like to press light, medium or heavy with this type of closing mechanism?

I'm doing vinyl, JPSS and plastisol transfers.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.