T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
892 Posts
Discussion Starter · #1 · (Edited)
DIY DTG R 1800 Epson paper and ink light flashing

Had it set to roll mode (pe censor is wired into a switch) it worked fine until had to change mainboard due to power serge. After installing the new main board I can't seams to get it back to roll mode printing, or sheet mode. See attached video, I could use some good advise! https://youtu.be/SrSXF3gJbaE
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.