T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
168 Posts
Discussion Starter · #1 · (Edited)
After looking high and low for a dip tank or suitable replacement that doesn't cost a kidney and half a liver I decided to build.

I started off with 1/2 MDF and used corner brackets inside of the the tank. We adhered shower pan liner on the inside for extra protection and to provide a smooth surface for the screens and actual bag liner.

We are using a Gorilla Tough 3.3 Mil bag to set inside the tank and so far no problems at all. We tested a little bit of the Ryonet 2 in 1 fully concentrated in a regular trash bag for 3 days dangling inside a cup to see if the chemical ate through the bag and it didn't so we figured this 3.3 bag shouldn't have any issues.

The tank has been in use for 2 days and no problems.


*** Sorry for the quick info and one lame pic. I didn't plan on posting about it but wanted to share the Gorilla Bag experience. - http://www.walmart.com/ip/35771407?...05593901&wl4=&wl5=pla&wl6=68495864941&veh=sem
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.