T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
decided i would try to build a dip tank, figured i'd post some pics :)


outside dip tank

http://i1252.photobucket.com/albums/hh565/dynamicdezigns1/IMG_20140502_174946_zps54f6456e.jpg

------------------------------------------------

dip tank with ball valve installed

http://i1252.photobucket.com/albums/hh565/dynamicdezigns1/IMG_20140502_175003_zpsf52d794e.jpg

------------------------------------------------

inside of dip tank to show drain

http://i1252.photobucket.com/albums/hh565/dynamicdezigns1/IMG_20140502_174952_zpsf9af8d6b.jpg

------------------------------------------------

this should hold about 6-8 screens with no problems.

we built the framing to have a recessed lip to hold a lid. lip has felt stripping all the way around to keep a tight seal on the lid.
inside, the seams were siliconed, lined with fiberglass paneling. after we sprayed the entire inside with flex seal, and we are still going to fiberglass the interior seams.

we installed 4 casters on the bottom.

cost of this was about $75 to build. (had fiberglass panels, and flex seal on hand) took about 2 hours to build
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top