T-Shirt Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hi guys, I'm still new to all this and I'm unsure if I'm even in the right forum!

I have made some dark t shirts but I keep getting little patches like this when I pull the paper back. (this isn't my photo but it's the same issue)
I am using sublimation ink as I use this for my normal sublimation prints, I am using dark heat transfer paper, my temp is on 190 (or 374) and I put it down for about 14 seconds and leave it for over 30 seconds as it says to do that on the paper. Any ideas?
Thanks
272712
 

·
Registered
Joined
·
3,654 Posts
I am using sublimation ink with heat transfer paper.
It just seems that it takes the ink up with the paper as I pull it back
1. The transfer has to dry before pressing.
2. You need to use a silicone sheet
If you do this, then what I said in my previous response is likely the issue. The transfer coating could be defective or contaminated
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top