T-Shirt Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a Versacamm on the way (yay) but have question... let's say i want to laminate some stickers. Would this be the proper workflow? Print, laminate, reload the print then cut?
 

·
Registered
Joined
·
950 Posts
Yes that is correct. When you set up your file in VersaWorks you set it to just print and also set it to print the registation marks. After it prints, feed out a little extra vinyl before cutting off the sheet. Then laminate and reload your graphic. In VersaWorks you then set it to just cut that file. The Versacamm will find the registration marks and then cut along your CutContour lines. Make sure to set your cut pressure higher and do a test cut before proceeding with the full cut process.
 
1 - 2 of 2 Posts
Top