T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9,739 Posts
You can use a transfer tape for printable HTV or maybe a high tack transfer tape for vinyl. You should also get the super sharp 60 degree Clean Cut blade. Do some test cuts to dial it in and do multiple passes on it if needed. We do it with our VersaCamm. We used 1 pass, 5 cm/sec, 200gf of pressure, offset at 0.500
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top