T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I am having an odd problem with my faithful Roland CM300...it cuts correctly on one-half of a project but on the other it is as though the cutting pressure changes and nothing is cut. One half cuts fine, the other does not. Anyone out there ever run into this problem and (a rhetorical question at best) why do things like this happen on the eve of huge project?

Thanks in advance for any advice or help.
 

· Registered
Joined
·
1,027 Posts
The second part I can answer from experience. It's Murphy's law. The first part, you will have to wait until someone with more experience then myself can answer.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top