Cutting Master & CE5000 Contour Cut Problem
Hi there, this is probably a total no brainer for somebody in the know 'cos its a complete noob question. I'm just getting down to trying to do some contour cutting for the first time in order to make a few stickers.
You can probably see from the picture below what my problem is. Cutting master two just transposes the job directly from the page rather than rotating it to take account of the way the job exits the printer.
Does anybody know what settings I'm missing or what I can do to get around this. Thanks for your time.
Seán
![]()
You can probably see from the picture below what my problem is. Cutting master two just transposes the job directly from the page rather than rotating it to take account of the way the job exits the printer.
Does anybody know what settings I'm missing or what I can do to get around this. Thanks for your time.
Seán
