T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Can anyone tell me if I need a special blade to cut Stahl's Soft Foam using the Silhouette Cameo 4?
  • The thickness is the same as Siser Brick (600 microns). Siser settings say you can use the autoblade.
  • Stahl's lists the Cameo 3 settings on the site and they require the Deep Cut blade.
Any experience anyone could share would be appreciated. Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top