T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I just purchased a Roland GX-24. I would like to take my tajima applique file and create a cut file from that. So...I took my applique file, deleted everything by the trace outline, exported it as a .jpg. Went to Corel Ver12 and imported it in. Traced the file and exported it as a .plt (plotter file). Then I went to Roland Cut Studio and imported it in....and.....it didn't work.

Can anyone help? I am at my witt's end!!

Thank you in advance for your time.

Pat
 

· Registered
Joined
·
3,506 Posts
here. i found this through the search function of this site. this is a valuable tool available to look up threads from the past.

http://www.t-shirtforums.com/vinyl-cutters-plotters-transfers/t76707.html

i think you'll really like this forum. also be aware that there are sub sections here that are for vinyl cutters and even embroidery. look around you'll be amazed. good luck and i hope this helps.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top