T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
56 Posts
Discussion Starter · #1 ·

I've been trying to cut Jet 3G Opaque paper. However the Craft Robo cuts the paper all the way though which causes the cuttings to come loose and then dislodge. Which in turn twists the paper and causes a jam, and the paper to get ripped and becomes good for nothing.
I used the Yellow blade (medium)-as suggested by the software with no carrier sheet -as suggested by many other users here
Is the yellow blade too long for cutting? What do others use? Or do I need a carrier sheet?

Thanks again
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.