T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
174 Posts
Discussion Starter · #1 ·
Hi I am setting up a print job in corel draw x3 and when I send it to print preveiw the right size page does not show up and neither does half the design. I have dotted lines arround 2 sides of the page. I can't center the design on the page cause some of the design hangs over the sides of the page. Can anyone tell me how to fix this. Please please please.

Thanks
Arpil
 

· Premium Member
Joined
·
7,117 Posts
You need to check your printer settings and make sure you have the correct printer selected, and that the page format for the printer is also selected correctly. Such as if you have it on letter size with a landscape setting in your corel draw, make sure the same settings are selected in your printer settings as well. It sounds like this is your problem :) Hope this helps.
 

· Premium Member
Joined
·
7,117 Posts
Glad I could help. I had a feeling that was it because when I go to print paper and still have my dtg selected it does that :).
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top