T-Shirt Forums banner

contour cutting woes

106 Views 2 Replies 2 Participants Last post by  musichsgcc
Hi everyone I am new to the forum but not to making tshirts. I just purchased a gcc 24 expert xl. The contour cutting is driving me crazy. I just about have it but there is something missing. Sometimes it recognizes all 4 reg marks and sometimes only two and stops. Tech support says to print the graphic with reg marks then to seperate contour from graphic and cut contour only. I have a problem seperating the graphic without the contour moving first. Does this make sense. If the contour moves it is hard to put it back into the right position. Does anyone else have this problem? I need help.
1 - 3 of 3 Posts
What are you doing to separate the contour from the graphic? The contour shouldn't move relative to the registration marks. What software are you using?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.