T-Shirt Forums banner

contour cutting with vinyl cutter mh 721

4K views 3 replies 2 participants last post by  przemmek 
#1 ·
Hello.
vinyl cutter mh 721 and flexistarter 10.

Just one question about contour cutting. After printing design with registraction marks and making ready each registration mark with laser light in the cutter there is command "Put your knife back and click OK". After click OK cutting starts but contour is cutting shifted about 1.5 cm to the left (It seems like size beetween laser light and knife). I dont understand. What I can to do. Obviously I didnt change knife with any laser point before because is pointless if I have laser next to knife. Mayby any settings straight into the cutter.
Please anybody could help me.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top