T-Shirt Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
94 Posts
Discussion Starter #1 (Edited)
I can get the Gx-24 to recognize all 3 registration marks but when it goes to cut, it does not cut the contour that was made in flexi. It goes to a corner and makes like a 8 pattern and comes back to the top of the page.

http://www.pyper.com/testcut2.FSis the file i am trying to cut... any ideas??

Thanks!!!

Kent
 

·
Registered
Joined
·
94 Posts
Discussion Starter #3
ya, isnt it sad you have to take a perfect vector file and turn it into a lousy bitmap then trace it with vector cut with all those jagged edges..... You would think it would be easy as pie to contour cut a vector image. There HAS to be an answer!!!!
 
1 - 3 of 3 Posts
Top