[archproject]

Hi there,

Can Anyone help me with the configuration of Graptec CE5000-40 or the Craft Robo Pro (15 Inch) in contour cutting JPSS for Lights and the 3G Opaque. I am just starting out and at the moment is doing alot of testing so here's what I understand

QUESTION 1
With JetPro Sofstretch (JPSS for lights) weeding is possible but with correct settings according to this post

http://www.t-shirtforums.com/heat-press-heat-transfers/t56386.html

but the post above is using the ROLAND GX24 I have the Graphtec CE5000-40-CRP (Craft Robo Pro) . Can anyone share with me the correct settings for the Craft Robo Pro to contour cut the JPSS and for weeding?

Force ?
Speed?
Quality?

QUESTION 2
With JPSS for lights I want the cutter to cut through the whole paper (using carrier sheet or solution mask from Stahls)

Force?
speed?
quality?

QUESTION 3
With the 3G Opaque, I want to cut and weed it , this should be straight forward. because this paper is designed for weeding anyway.

Force?
speed?
quality?

Question 4
In Cutting Master 2, there is a selection for the condition of cutting from condition 1 to 8. What are these ?

Thanks in advance.

Archproject

 

[dkdesign]

Can anyone respond on this now? Do you need a specific blade?

Edit: I got mine working good with 3G and i was using Force 10, speed 20 and Quality 1. The reason i couldnt get it to work before, was my blade/knife wasnt far enough out = it it still sticky, no matter how high my force was.