T-Shirt Forums banner
Cancel

Contour cut gets worse from right to left Puma III 132S

1349 Views 2 Replies 1 Participant Last post by  artwerkinmotion, 
A
I sure hope someone can help me. This has been an ongoing issue since I bought it brand new. I have attatched a pic. I have a Mutoh 1324 and a GCC Puma III 132s. I have used different combinations of software coming up with same results. When cutting the images the contour cut starts out ok on the right side of the vinyl cutter and gradually cuts into the images the further out to the left it goes. No matter where I start to cut whether it starts with the last one or the first one it follows this pattern on everything I cut.


Sent from my VS990 using Tapatalk
See less See more
Reply
Save
Like
1 - 3 of 3 Posts
A
Looks like I will have to answer my own question, believe me as soon as I get the answer I will post. At this point I just dont know other than a suggestion it may be a memory problem. maybe the servo motor is lagging? Looses it registration. Output size compensation doesnt help, X Y alignment isnt the answer. If this machine cannot be diagnosed and fixed it will be time pay the money for a better vinyl cutter that can perform.
Very disappointed all the way around.
Reply
Save
Like
A
artwerkinmotion said:
Looks like I will have to answer my own question, believe me as soon as I get the answer I will post. At this point I just dont know other than a suggestion it may be a memory problem. maybe the servo motor is lagging? Looses it registration. Output size compensation doesnt help, X Y alignment isnt the answer. If this machine cannot be diagnosed and fixed it will be time pay the money for a better vinyl cutter that can perform.
Very disappointed all the way around.
Click to expand...
Problem solved:
After contacting GCC America a technician did a remote view on my Puma III 132 Cutter and PC. He updated my firmware and installed the new version of GreatCut 4 . Now output size compensation can be applied because everything is even from right to left if needed to be. Good job GCC America.


Sent from my VS990 using Tapatalk
Reply
Save
Like
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
T-Shirt Forums
A forum community dedicated to T-shirt merchants, professionals and enthusiasts. Come join the discussion about graphics, commerce, dyes, prints, collections, guides, displays, styles, scales, equipment, accessories, reviews, classifieds, and more!
Full Forum Listing
Explore Our Forums
Screen Printing General T-Shirt Selling Discussion Graphics and Design Help Member Introductions Heat Press and Heat Transfers
Top