T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I would appreciate an update of the problems I have been reading about regarding the bad fill patterns not punching out like the screen display. Have they got this resolve as far as you know? I have talked to ColDesi and they of course say they have never heard of this problem and everyone is making money hand over fist with no problems.

I have had a embroidery shop ( a 12 head Tajima, plus four single heads, vinyl cutting,computer engraving and DTG printing on darks). saying that, all machines have bugs, but the difference is some have inherent designs / software problems, and other bad electronics that can be resolved.

I have looked on the forums and saw various posts, but none that I could see recently 2017-2018.

Once again I am thinking of buying another machine - ProSpangle.

Any advice would be very helpful and appreciated!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top