T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hello All,

I have two machines Brother GT341 (since 2015) and i have the same problem on these machines. All the morning, when i turn on the machine, i have the message 6108, i turn off the machine and after i turn on again the machine and the message disappears.

I don't understand. I changed already the PCB, I cleanned inside the machine but always the same problem on these two machines.

Thanks you for your help.

Ced
 

· Registered
Joined
·
9 Posts
Discussion Starter · #3 ·
Hello WGIant,

Thanks you for message.

I already changed the small two felts on the rails. Before, i cleanned the rail with the product of maintenance. I cleanned also the inside of the machine, the shaft, made the CR Speed, cleanned the Encoder Strip, changed the PCB Encoder...

The problem is just the morning when i turn on the machine for the first time in the day. After, no message in the day.

Thanks you.

Julien.
 
1 - 2 of 2 Posts
Top