T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Sometimes having issues clearing the edge on the top colors when using an underbase. It's just the amount that is choked on the underbase. I'm assuming that sometimes that amount is not making contact with the substrate but pressing harder doesn't really work. Any help or ideas would be appreciated.
 

Attachments

·
Registered
Joined
·
3,758 Posts
The amount of chock required depends on too many variables unfortunately.
I'd start with 3 pixels, use a soft squeegee, and then gradually reduce the ink until I can print with minimal pressure.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top