T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi Everyone,

I have been reading a few different ChromaLuxe Aluminium pressing documents. I have noticed that all of them recommend that a standard 40x50cm heat press should press the same size panel for significantly less time the a very large pneumatic press – any ideas why this is, I would have thought the smaller press would need more time while the large unit could get things done much faster?



Each document gives different time ranges to press for but the smaller press is always over a minute faster.



Thanks.
 
1 - 1 of 1 Posts
Top