T-Shirt Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
hi there .

Im currently using a xerox media to print on and it is fine for my xbox skins but im trying to do the iphone and the ipad and it just will not conform at the curved edges. but it is great stuff and only cost £70 for 760mm x 50m . but i need a more conformable workable media , i think maybe the stuff i am using is calandered and i need cast ? but i need it as cheap as it gets but still doing the job . im using a versacamm 300v - also this stuff leaves a slight residue and is very adhesive maybe sumthing that doesnt leave residue and not so sticky it pulls the paint off the walls as i am thinking of going into wall art also.

Any advice appreciated !

Roy
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top