changed motherboard now it does not print

Hi Dan,

I'm not familiar with the Anajet but did you try clearing out your print spool, reboot computer. Double check USB cords. Go to Windows Device Manager and make sure there are no yellow "error" marks. When you installed new board are you 100% sure it is all hooked up correctly? Make sure all wire connections are tight. If all else fails unplug and replug all wires on mainboard. Try installing software onto a laptop or another computer to see if you have same problem or to see if the problem is the computer. Switch out USB cable.

I know that is just a list of basic stuff but it very well could be something easy that you over looked.

Good Luck!
-Jim

are all the jumpers set like the original board was?
could also be a BIOS issue

onsit tees said:

i replaced my motherboard on my anajet sprint know the computor does not talk to the machine say sent to print but nothing prints do i have to do anything because it has a different board in it

Click to expand...

I know when you chage a head, you have to "register" the serial number so the rest of the electronics "see" each other. You may try to use the "adjustment" program to see if that reads everything. This will give you a good idea on whether communication is happening.

I changed motherboard and head once. Delete the driver in your window and reinstall the driver only.

rubysky said:

I changed motherboard and head once. Delete the driver in your window and reinstall the driver only.

Click to expand...

I'd agree with this. When you install a new motherboard, your computer thinks it's a new computer and your old installation won't work because it's looking for a different printer associated with that driver.

thanks every one i fired up the machine last night after work and it started to print but know i have a different problem go figure my luck