T-Shirt Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4,009 Posts
here are the new feb 2020 windows drivers and apr 2020 cutting master drivers
For Windows: Connect the USB cable after the device driver was installed to the PC.
make sure when using cutting master you are set to 'gp-gl' and not 'hp-gl'
do it manually, not auto, and see if it makes a difference
see here

try using a thumb-drive instead, that might narrow it down to a windows issue, if the above does not help
 

·
Registered
Joined
·
4,009 Posts
i just came across this which may be your issue:

disabling the 'driver signing verification'
check here


Option 1 – Command to Enable or Disable
Click the “Start” button.
Type “command“.
Right-click on “Command Prompt” and select “Run As Administrator“.
Do one of the following:
To disable device driver signing, type “BCDEDIT /set nointegritychecks ON” then press “Enter“
To enable device driver signing, type “BCDEDIT /set nointegritychecks OFF” then press “Enter“
Option 2

Select the “Start” button.
Type “startup”.
Select “Change advanced startup settings“.
Select “Restart now” under the “Advanced startup” area.
Select “Troubleshoot“.
Select “Advanced Options“.
Select “Startup Options“.
Select “Restart“.
A menu will appear where you can press “7” on your keyboard to choose “Disable driver signing enforcement“.
 

·
Registered
Joined
·
4,009 Posts
Using Silhouette Design software to cut with Graphtec CE-Lite 50. I prefer it over their software. The problem is when I cut it seems to cut my image 3X as big as it needs to be and I keep wasting vinyl. Any suggestions? TIA
what does the cut preview show?

do you have the newest ce-lite 50 drivers for studio?
you need studio version 4.3.254 or later
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top