T-Shirt Forums banner
1 - 1 of 1 Posts

605 Posts
Discussion Starter · #1 ·
You know the "shuttle table" (or long platform) they have on the heat press sites where it allows you to layout and set up a shirt on one end while a shirt is being pressed on the other end, then just slide it over and press the shirt you just set up...and you can start seting up another shirt on the first end ....

I might be wrong ..but it seems that this is just a platform double the size of the heat press that you can simply make with a thin piece of plywood?:confused:

I've seen them for $500 - $700

whats the big deal about these things?

I might as well just buy 2 heat presses if they cost as much as one.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.