T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a Roland PNC 1100 CAMM-1, which doesn't appear to be receiving the correct signal from SignBlazer. I did a self test on the cutter itself without it being attached to the computer, and it cut perfectly.

Here's what I've been able to determine so far: The computer has the plotter assigned to COM1. In the Device Manager I made sure it's set to "Hardware." I tried every single port setting in SignBlazer (COM1, COM2....LPT1, LPT2, etc.), but nothing happens. I also went to the Roland Driver I have installed on the computer and changed it to LPT2 and repeated the process, but still get nothing. Any help would sure be appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top