T-Shirt Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Yesterday something broke in my heat press and the third digit won't work on the temp, meaning it won't go up past about 220 degrees F.

I use an Anajet and was wondering if anyone knew if the print would still bind if I pressed it for twice the normal amount of time at that temp while I am waiting for my new heat press to be shipped in.

Thanks!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top