[JoshEllsworth]

As part of our "Official Help Forums" we'll be publishing a weekly Tip Jar How To Video Series - we'll be updating this thread weekly...but for now I need to catch you up since we're 1 month in Please feel free to post any questions or share any tips that you may have that relate to the topics....

GO T-Shirt - 4 layer design
[MEDIA]http://www.youtube.com/watch?v=8ABvtGxfnZo[/MEDIA]

Break T-Shirt - Wrap Around Print
[MEDIA]http://www.youtube.com/watch?v=ipIuIxsqHjc[/MEDIA]

Better Tracking with your vinyl cutter
[MEDIA]http://www.youtube.com/watch?v=-c-b6oCu4bA[/MEDIA]

Selecting a Blade for your cutter
[MEDIA]http://www.youtube.com/watch?v=BQsv0d4FOcU[/MEDIA]

 

[vadan]

Great videos Josh, can't wait to see what else comes up over the next few months.

I have a question if I may, regarding video 1. Everytime I do multi-layer prints I get indentations where the layers overlap, I always do each layer with just enough pressure to adhere and then 1 final press to seal the layers. But when I use slight pressure the adhesive from the vinyl tends to leak out and I end up with indents and a thine layer of dry adhesive.

What am I doing wrong, what's the general practise to follow doing layers?

Thanks,

Raj

 

[JoshEllsworth]

Thanks for commenting Raj...layering materials and the results varies by material type. The issue you are experiencing is not a new one...one tip I can give you is to use a thin dish towel or even brown paper towels as the cover sheet for your final application...the adhesive that is squeezing out should be picked up by the towel....

 

[JoshEllsworth]

This week's Tip Jar video tutorial is all about saving money by reducing waste and accommodating scrap material on your vinyl cutter!

[MEDIA]http://www.youtube.com/watch?v=tQWPYKKITT4[/MEDIA]

 

[JoshEllsworth]

This week's Tip Jar Tutorial showcases a Luxe-T garment with an all over print completed with 5 colors of heat transfer vinyl:

[MEDIA]http://www.youtube.com/watch?v=jKsq_MRFbos[/MEDIA]

 

[JoshEllsworth]

This week's edition of Tip Jar is all about adjusting the offset setting on your vinyl cutter:
[MEDIA]http://www.youtube.com/watch?v=Ne71aXXp4BY[/MEDIA]