T-Shirt Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi
I'm just purchase a T-Jet 2 and it came with a bulk ink system. It was all apart I put it together I draw ink into to the cartridges but
it keep going back to the bulk system. Does
not stay in the lines. I got this unit has a square box were the bottle seat on top. I believe it's an american screen printing system. Just wondering if I have a bad connection on the line that is drawing air in. I have put a book under the bulk system to see if it would help but no it still empties the lines out.Does anybody have any suggestion.
 

Attachments

·
Registered
Joined
·
21 Posts
I believe your shelf that holds the ink bottles is a little low and is creating a siphon effect. In the manual it explains how to adjust your self for the altitude. If you have more problems Alex at Equipment Zone might be a help.
 

·
Registered
Joined
·
126 Posts
I can't tell from the picture but you might need to raise the inks a little more, ink levels should be same height as the print head. If you have them at the same level, it could be that air is getting into the ink lines from somewhere close to the cartriges.
 
1 - 4 of 4 Posts
Top