buidding a wash out booth

2316 Views 7 Replies 5 Participants Last post by DKgrafix, May 17, 2012

konaboy1

Discussion Starter · May 16, 2012

anyone ever build a washout booth?if so u got any ideas u would like to share

Save

1 - 8 of 8 Posts

Lucky7Graphix

· #2 · May 16, 2012

I tried a couple times and got fed up and just bought a table top one from silk screening supplies and it works great.

Save

TshirtStan

· #3 · May 16, 2012

I always wanted to build one and finally did. I can't upload the pics for some reason. PM me and I will get them to you as well as a good how to.

Save

konaboy1

Discussion Starter · #4 · May 16, 2012

ok thanks pics would be great but im not sure how to pm im new to this site

Save

Hegemone

· #5 · May 16, 2012

I put plastic shelving in a tub enclosure and a screen filter in the drain. It was in a spare bath without windows so it was also my coating room.

See less See more

Save

I used a mop sink from Home Depot or Lowes. I bought a sheet of FRP panel and glued it on a sheet of 1/2 inch MDF. Then cut it accordingly. I built the frame out of 2x4's and you can pretty well see how it is attached from there. I glued a shower curtain and dropped the front down to allow for the water spray. i don't have a lot of time to answer any questions...but use the pics to get the general idea.