T-Shirt Forums banner

Brother Mfc-j4420dw

901 Views 0 Replies 1 Participant Last post by  Precision design
I just recently bought a Brother printer Mfc-j4420dw for sublimation. it came with factory inkjet cartridges that I had to install to get the printer up and running. I then switched to my refillable cartridges with the dye sublimation ink.

I ran about 30 sheet of paper through the printer to make sure I got all the inkjet ink out of the lines.
when I printed onto the sublimation paper, and tried to press it, (400 degrees F at 40 seconds) 100% polyester shirt, the image only showed in yellow. but the image I printed is an American flag text image, what am I doing wrong? any advice would be very helpful.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.