T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
7 Posts
Discussion Starter · #1 ·
I have changed something with the board size (I think), so now after printing is done and the machine should output the board it bangs into the front and shows an error message.

I guess this is a common problem, but haven't been able to found any thread about it. Can someone please point me in the right direction?

I'm using Blazer express
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.