T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi Everyone, Recently bought a 2018 Roland BN20, prints beautifully, but i can't figure out how to get it to cut the design that i have printed. Obviously I am missing something but i really don't know where to start. Any advice is appreciated.
Al Burke
 

·
Registered
Joined
·
8 Posts
I am new to this also an have the 540v are you adding the cut line with the correct color I would assume if you are using versa works that you would need the roland cutline pallett or you would need to go in and create a cutline for it to be able to recognize it
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top